Every card in the T1
Will it fit
Does the PowerColor Hellhound Radeon RX 9060 XT 16GB fit in the FormD T1 V2.5?
Doesn’t fit
No. The PowerColor Hellhound Radeon RX 9060 XT 16GB is 5 mm too long and no thickness to spare (2 of 2 slots) for the FormD T1 V2.5.
Length330 of 325 mm5 mm over
Height120 of 140 mm20 mm spare
Thickness2 of 2 slots0 slots spare
Exact measurements
| Size | PowerColor | T1 | Room |
|---|---|---|---|
| Length | 330 mm | 325 mm | 5 mm over |
| Height | 120 mm | 140 mm | 20 mm spare |
| Thickness | 2 slots | 2 slots | 0 slots spare |
NCASE's published spec
Rather have it built?
We build the RX 9060 XT into small PCs by hand, each tested and shipped with its own benchmark results.
Questions
- Does the PowerColor Hellhound Radeon RX 9060 XT 16GB fit in the FormD T1 V2.5?
- No. The PowerColor Hellhound Radeon RX 9060 XT 16GB is 5 mm too long and no thickness to spare (2 of 2 slots) for the FormD T1 V2.5. Length 330 of 325 mm, height 120 of 140 mm, thickness 2 of 2 slots.
- Where do these numbers come from?
- NCASE's published spec; card size from PowerColor's spec page. Checked October 2026. Makers measure differently and connectors add a few millimetres, so treat a tight result as a reason to measure.
Sources
- Case: NCASE’s T1 specifications, checked October 24, 2026. NCASE (which now makes the FormD T1) lists cards up to 140 x 325 mm and 3.25 slots, with CPU cooler height falling 5 mm for each quarter slot of card thickness.
- Card: PowerColor’s spec page, checked October 23, 2026. PowerColor lists 330 x 120 x 40 mm with the bracket and 310 x 100 x 40 mm without; we use the larger figures.
- The T1 trades card thickness against CPU cooler height: 73 mm of cooler with a 2-slot card, 48 mm with a 3.25-slot card.
This card in other small cases
- Cooler Master NR200PTightNo length to spare (330 of 330 mm)
- Cooler Master NR200P V2Fits27 mm of length to spare
- Fractal Design Era 2Doesn’t fit4 mm too long
- Fractal Design RidgeTightOnly 5 mm of length to spare
- Fractal Design TerraDoesn’t fit8 mm too long
- Jonsbo Z20Fits33 mm of length to spare
- Lian Li A3-mATXFits85 mm of length to spare
- Lian Li A4-H2ODoesn’t fit8 mm too long
- Lian Li Q58Doesn’t fit10 mm too long
- NCASE M1 V6.1Doesn’t fit8 mm too long
- NCASE M2Fits29 mm of length to spare
- Phanteks Evolv Shift XTDoesn’t fit6 mm too long
- SilverStone SG13Doesn’t fit60 mm too long
- Sliger CerberusTightNo length to spare (330 of 330 mm)
- SSUPD Meshroom S V2Fits23 mm of length to spare
Other RX 9060 XT cards in the T1
Check another pair with the fit checker.
Based on published dimensions, not a guarantee. Check cable, cooler and connector clearance before you buy.